All
- All
- Product Management
- News and Information
- Introduction content
- Enterprise outlets
- Frequently Asked Questions
- Corporate Video
- Company Portfolio
Introduction to the Asphalt Mixture Stability Tester
As for asphalt, I’m sure everyone is quite familiar with it. In fact, quite a long time ago—or even ten years ago—we could still find these materials readily available in our homes. But with the rapid advancement of high technology today, using asphalt to repair houses at home has become exceedingly rare. Nowadays, asphalt is mostly used on highways instead.
2021-09-16
Features and Operating Procedures of the Asphalt Mixture Compaction Tester
It can perform automatic counting, automatic compaction, and automatic shutdown. It also features a hammer-hanging bracket and a manual handle for easy lifting of the hammer. The semi-automatic mold installation makes it even more convenient to install and remove molds.
2021-09-14
Introduction to the Asphalt Mixture Compaction Tester
1. First, connect the three plugs at the back of the cabinet properly. The “motor” should be connected to the motor input port on the cabinet, the “non-contact proximity switch” should be connected to the counting port, and the “power supply” should be connected to the power supply port. At the same time, make sure the neutral wire is properly connected.
2021-09-09
Precautions and Instructions for Use of the Asphalt Mixture Compaction Tester
1. First, connect the three plugs at the back of the cabinet properly. The “motor” should be connected to the motor input port on the cabinet, the “non-contact proximity switch” should be connected to the counting port, and the “power supply” should be connected to the power supply port. At the same time, make sure the neutral wire is properly connected.
2021-09-06
Instructions for Using the Asphalt Penetration Tester
1.1 This method is applicable to the determination of the penetration of road petroleum asphalt, polymer-modified asphalt, and the residue remaining after distillation of liquid petroleum asphalt or emulsified asphalt—measured in units of 0.1 mm using a needle. The standard test conditions are as follows: temperature 25℃, load 100 g, and penetration time 5 s.
2021-09-01