- All
- Product Management
- News and Information
- Introduction content
- Enterprise outlets
- Frequently Asked Questions
- Corporate Video
- Company Portfolio
Precautions and Instructions for Use of the Asphalt Mixture Compaction Tester
2021-09-06
Precautions for the Asphalt Mixture Compaction Tester
1. The counter counts in a forward-counting manner.
2. The next time you strike, first press the reset button and then the start button.
3. When compaction is in progress and the machine needs to be stopped or malfunctions, you can press the stop button to halt the compaction apparatus.
4. The chain tension should be checked regularly, and if its sag exceeds 10 mm, it should be adjusted.
5. Do not start the compaction machine when no mixture is loaded. When not in use, place cotton yarn or shredded paper inside the mold.
Instructions for Using the Asphalt Mixture Compaction Tester:
1. First, connect the three plugs at the back of the cabinet properly. The “motor” should be connected to the motor input port on the cabinet, the “non-contact proximity switch” should be connected to the counting port, and the “power supply” should be connected to the power port. At the same time, make sure the neutral wire is properly connected.
2. After completing the above steps, rotate the “Preset” dial to set the desired number of compaction cycles, ranging from 1 to 99. When you flip the power switch, the digital display on the switch panel will show “00,” and the power indicator light will illuminate.
3. Press the start button to activate the controller; the status light will illuminate, and the digital display will show “00.” The motor will start rotating, raising the hammer to compact the material. Each time the hammer strikes, the digital display will increment by one. Once the preset number of strikes is reached, the motor will stop, and the indicator light will turn off.
4. Press the Pause button to halt the operation; the status indicator will turn off. Press the Start button again to resume normal operation. If any abnormal condition occurs during operation, press the Pause button. At this time, the digital display will show the number of times the button has been pressed. After completing one experiment, first press the Reset button, then press the Start button.
Relevant Information
The main advantages of the penetration tester are:
2023-11-02
The working principle of the compaction apparatus mainly includes the following points:
2023-10-23
2023-10-13