- All
- Product Management
- News and Information
- Introduction content
- Enterprise outlets
- Frequently Asked Questions
- Corporate Video
- Company Portfolio
Instructions for Using the Asphalt Mixture Compactor
2022-01-13
Instructions for Using the Asphalt Mixture Compaction Tester:
1. First, connect the three plugs at the back of the cabinet properly. The “motor” should be connected to the motor input port on the cabinet, the “non-contact proximity switch” should be connected to the counting port, and the “power supply” should be connected to the power supply port. At the same time, make sure the neutral wire is properly connected.
2. After completing the above steps, toggle the “Preset” dial to set the desired number of compaction cycles, ranging from 1 to 99. When you turn on the power switch, the digital display on the panel will show “00,” and the power indicator light will illuminate.
3. Press the start button to activate the controller; the status light will illuminate, and the digital display will show “00.” The motor will begin rotating, raising the hammer to compact the material. Each time the hammer strikes, the digital display will increment by one. Once the set number of strikes is reached, the motor will stop, and the indicator light will turn off.
4. Press the Pause button to halt the operation; the status indicator will turn off. Press the Start button again to resume normal operation. If any abnormal conditions occur during operation, press the Pause button. At this time, the digital display will show the number of times the button has been pressed. After completing one experiment, first press the Reset button, then press the Start button.
Relevant Information
The main advantages of the penetration tester are:
2023-11-02
The working principle of the compaction apparatus mainly includes the following points:
2023-10-23
2023-10-13